1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease at the pins. Prior to connection, verify the grease over the surfaces of pins, and when the volume of grease is smaller, apply grease with bare hands. (If gloves are utilized, the grease is going to be absorbed from the gloves.)
Example: Once the connecting link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted with the roots in the pins. Should the O-rings come loose due to vibration during transport, refit the O-rings in towards the roots from the pins.
In this instance, make sure to return the grease collected on the roots on the pins for the central surfaces on the pins, extra at portion A than at portions B shown from the above illustration. (Portions A is worn on account of sliding with the bushings.)
two.The chain might be most simply connected about the teeth of the sprocket. Engage the back links at each ends from the chain using the sprocket teeth and fit connecting pins. In the event the sprocket might be moved, the chain may also be connected around the loosened side.
three. Connecting procedure
1.Confirm that O-rings are attached for the roots from the pins.
two.If the volume of grease utilized around the connecting pins is tiny, coat the pins with grease on the central portions.
3.Insert the connecting pins in to the bushings on the inner backlinks at both ends.
four.Verify the grease is utilized on the total face of your O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and when pressing the connecting plate, install the spring clip. Confirm regardless of whether the head (the finish without a split) with the spring clip is turned while in the feeding route with the chain. (See the next illustration.)
six.Make sure to verify the spring clip is securely fitted from the clip grooves of your connecting pins.
This completes jointing in the connecting link. Note that grease over the surfaces of connecting pins and O-rings is usually eliminated for the duration of installation function. In this instance, re-grease employing the grease within the surface on the base chain or the grease while in the polyethylene bag by which the connecting hyperlink was contained.